SuperCross
The SuperCross Hot Wire system is the answer to the problem of producing foam parts with wire cuts in two directions. To date this has been handled by a single-wire machine with the operator having to re-orient the block every time. Velocity's unique dual-wire SuperCross does cutting at 90 degrees through blocks up to 8 ft long, 8 ft wide and 4 ft high. It utilizes one tool path thereby eliminating mis-cuts, ,making it more accurate as well as being faster. This all adds up to a marked improvement in daily through-put. The towers park out of the way allowing 2 sides clear for loading and the cable chains are located under the machine so there is nothing to step over accessing the platform.
​
FEATURES
-
Very rigid base construction, completely supported and levelable
-
Smooth operating belt drive
-
4 towers in 2 pairs working 90 degrees to each other
-
The priority axis pair can also be run individually to create angled cuts
-
Direct drive high torque motors negate backlash completely
-
Teknic Nema 34 servo motors: powerful, accurate, resistant to electrical noise, the highest quality in their class
-
Highest quality SKF linear bearings throughout for best accuracy, reliability and long life
-
Wire control includes control of corner and start pauses
-
220 Volt single phase configuration allows installation in more locations – no need for 3 phase power
DIMENSIONS
Length: 132” (335 cm)
Width: 132” (335 cm)
Deck height 14" (35.5 cm)
Height: (Max) 71” (180.3 cm)
Electrical requirements: 220-240 Volt
30 Amp single phase 50 or 60 Hz
WORK AREA
Length: 100” (254 cm)
Width: 100” (254 cm)
Height: 49” (125 cm)
​
OPTIONS
​
Operator's console
PACKAGE INCLUDES
Machine
PC with Windows 10 and WinCNC installed and ready to run with VMS control
21” 1280p monitor (or upgrade)
All cables
​
13-month warranty on all parts and workmanship.
Non-expiring technical support, you call - we help.
​
​